Using The Speakers - T+A KS 350 Handbuch

Using the speakers

The speaker terminals can accommodate cables with a cross-
sectional area of 6 sq mm. We recommend one of the high-
quality tailor made cables from the  range.
We recommend that you ask your specialist  dealer for
advice on choice of speaker cables, as they have a significant
influence on the sound.
It is important that you consider the mechanical stability of the
cable. Firmly twisted strands of fine wire provide optimum
transmission of the music signal. 's own range comprises
cables of various types, all of the highest quality.
To fit speaker cable to the high-quality terminal clamps fitted to
 loudspeakers, unscrew the cap, fit the conductor in the
cross-hole and re-tighten the cap.
Take care to screw the terminal clamps down firmly, and check
that there are no stray wire 'whiskers' which could cause a short-
circuit.

Be sure to connect the red (+) terminal clamp at the speaker to
the red (+) terminal at the amplifier, and the black (-) terminal
clamp at the speaker to the black (-) terminal at the amplifier.
If the speakers are connected with incorrect polarity, they will
work 'out of phase', and pro-per stereo-phonic reproduction will
not be possible. The most obvious sign of incorrect phase is that
the sound is diffuse, and bass response poor.
30