Inhaltsverzeichnis
Werbung
4. Mark the buttonhole area on the fabric. Place both
1
2
3
NOTE: Make sure there is not a gap between the slider
and the spring holder
the buttonhole will be different lengths
4
5.
6. Raise the presser foot and remove fabric. Cut
To sew another buttonhole, turn the stitch selection knob
in either direction to an adjacent stitch and then re-set it
to the buttonhole.
When buttonhole sewing is finished, push the buttonhole
lever upward as far as it will go.
Fine Adjustment For Buttonholes
If the stitches on each side of the buttonhole are not
balanced, adjust them with the fine adjustment lever for
buttonholes.
Slide the lever to the right (+), if the left side is more
dense than the right side.
Slide the lever to the left (–), if the left side is less dense
than the right side.
72
threads to the left under the foot. Insert the fabric
under the foot and turn the flywheel until the needle
comes down into the fabric. The needle should go in
exactly at the marked line for the buttonhole. Lower
the presser foot.
3
. If there is a gap
The buttonhole will automatically sew:
1.
the front bartack and zigzag on left side
2.
back bartack
3.
zigzag on right side
The machine will automatically stop when the
buttonhole is complete (Model 3230 only).
threads at least 10 cm (4") long. Pull the needle
thread to the wrong side of the fabric. Knot the
threads.
To cut the buttonhole open, place a pin just inside the
bartack (to prevent accidentally cutting bartack) and
use a seam ripper.
1
2
, the sides of
4
.
Werbung
Inhaltsverzeichnis
