Installation And Connection; Installation Location And Sensor Position - Sentiotec Concept R combi black Montage- Und Gebrauchsanweisung

Installation instructions, only for experts

4. Installation and connection

Take the following points into account when positioning and connecting the sauna
heater:
WARNING!
Danger of electric shock
● The sauna heater may only be installed and connected when the
power supply is disconnected.
● The electrical connection may only be performed by a qualified electrician or
similarly qualified person.
● A fully disconnecting all-pole isolating device compliant with overvoltage
category III must be fitted on site.
● The Concept R combi sauna heater is a free-standing heater. It does not need
to be attached to the floor or sauna wall.
● Do not place the sauna heater on a floor made from an easily flammable
material such as wood or plastic. Suitable flooring includes ceramic tiles, for
example.

4.1. Installation location and sensor position

Position the heater centrally in front of the air intake opening in the cabin wall.
Observe the safety distances to the cabin wall specified in Fig. 1.
Install the temperature sensor with excess temperature cut-out to the cabin wall
above the centre of the sauna heater. Maintain a distance of 15 cm to the sauna
cabin roof.
If there is sufficient ventilation, the Concept R sauna heater can also be
set up as a free-standing device. In this case, fit the temperature sensor
to the cabin roof above the centre of the heater.
p. 10/26