Safety Information For The Installer - Sentiotec Concept R combi black Montage- Und Gebrauchsanweisung

Instructions for installation and use

2.2. Safety information for the installer

● Installing and connecting the sauna heater may only be performed
when the power supply is disconnected.
● Installation may only be performed by a qualified electrician or
similarly qualified person.
● A fully disconnecting all-pole isolating device compliant with
overvoltage category III must be fitted on site.
● Always use silicone cables that are heat-resistant up to 150 °C
to connect the sauna heater.
● Only install one sauna heater in the cabin. The Concept R combi
sauna heater must not be used together with other sauna heaters
in a sauna cabin.
● The roof and walls of the sauna cabin must be manufactured
from low-resin, untreated or thermally treated wood, e.g. Nordic
spruce, hemlock, pine or fir, or from laminated wooden materi-
als. If laminated wooden materials are used, make sure that the
adhesive used in them does not give off formaldehyde. If other
materials than wood are used in the sauna cabin, these materi-
als must be heat-resistant and corrosion-resistant and must not
cause any negative effects on the health of the sauna users.
● The height of the sauna cabin must be at least 2.0 m.
● Observe the specifications on volumes and on ventilation of the
sauna cabin in chapter 10. Technical data on page 24.
● When positioning the sauna heater, observe the minimum safety
distances (see chapter 4.2. Safety distances on page 11).
● Also comply with the regulations applicable at the installation
location.
● For your own safety, consult your supplier in the event of prob-
lems that are not explained in sufficient detail in the installation
instructions.
p. 6/26