Dürkopp Adler 550-12-23 Bedienungsanleitung Seite 223

8. RESET
BEL not received (command
311
SENDE_FLAG)
ETX not received (command
312
SENDE_FLAG)
313 checksum error (command
SENDE_FLAG)
320 STX not received (command
SENDE_STATUS_FEHLER)
321
time out while receiving status,
ETX not received (command
SENDE_STATUS_FEHLER)
322 checksum error (command
SENDE_STATUS_FEHLER)
324
"NAK" sent by sewing motor,
i.e. parameter error/control not
initialized
329 init error at status request
With the key combination 0H, F and Y when the machine is turned on,
an original loading of all parameters at the standard values is
conducted.
–
Hold down keys 0H, F and Y when turning on the machine.
The display shows "Urladen".
–
If the parameters are to be reset to the standard values :
Briefly operate the "E" key.
With the 550-12-26 the tape advance unit must be turned on again
after a reset. The machine parameters 3 and 16 must be set to the
value 1.
–
Hold down the "Y" key and tap the "F" key.
The parameter menu is turned on.
–
Advance to parameter 3 through repeated pressing of the "Y" key.
–
Press the "1" key.
The tape advance is turned off.
–
Advance to parameter 16 through repeated pressing of the "Y" key.
–
Press the "1" key.
The tape advance mechanics are turned off.
–
Hold down the "Y" key and tap the "F" key.
The parameter menu is turned off.
change DA-/Efka-control
change DA-/Efka-control
change DA-/Efka-control
change DA-/Efka-control
change DA-/Efka-control
change DA-/Efka-control
change DA-/Efka-control
change DA-/Efka-control
3
37