Needle Bar Guide; General Information; Setting Of The Guide Holder - Dürkopp Adler 550-12-23 Bedienungsanleitung

2.3

Needle Bar Guide

2.3.1

General Information

4
2.3.2

Setting of the Guide Holder

10
1
The 550-12-23; -24; -26 series is equipped with a split needle bar
guide.
The fixed part with the needle bar is screwed directly onto the cast
body. The second part with the transport foot bar is attached movably.
The, with yellow paint and through adhesive secured against turning,
screw 1 must touch in the arm.
The guide bolts 2 (in the guide) and the right guide bolts 3 in the arm
have been set at the factory so that the guide can move easily and
without play.
The positions of the two guide bolts may not be altered.
2
The guide holder 6 must lie parallel to the bottom edge of the arm
head.
Caution Risk of Injury!
Before adjusting turn the main switch off.
–
Set the screws 4 so that the guide holder lies parallel to the
bottom edge of the arm head.
6
3