Mounting Depth Wheel - Stihl FSE 60 Gebrauchsanleitung

English
2
1
The blade (1) on the deflector (2) trims
surplus line to the correct length – avoid
tapping the mowing head more than
once at a time.
Line feed operates only if both lines still
have a minimum length of 2.5 cm.
If the line is shorter than 2.5 cm:
N
Switch off the trimmer.
N
Disconnect the plug from the power
supply.
N
Turn the trimmer on its back.
N
Press down the cap on the spool as
far as stop.
N
Pull the ends of the lines out of the
spool.
If the spool is empty, see "Replacing
Nylon Line".
38
Removing the mowing head
STIHL AutoCut
N
Hold the mowing head steady.
N
Unscrew the cap counterclockwise.
Replacing nylon line
STIHL AutoCut
See chapter on "Replacing Nylon Line".

Mounting Depth Wheel

The depth wheel is included in the scope
of supply or is available as a special
accessory.
It limits the working range of the mowing
line.
– It helps reduce the risk of the
rotating mowing line causing
damage (e.g. tree bark).
– It maintains the correct ground
clearance when edging.
2
B
C A
3
1
The depth wheel (1) can be locked in
three different positions (A, B or C) on
the support (2). This allows the reach of
the mowing line to be varied.
A Working range of mowing line
extends beyond the outside
diameter of the depth wheel, e.g. for
lawn edging.
B Working range of mowing line
extends up to outside diameter of
depth wheel.
C Working range of mowing line does
not reach as far as outside diameter
of depth wheel, e.g. for mowing
around trees.
FSE 60, FSE 71, FSE 81