Stopping; Counter Function; Selector Locking Function - Zummo Z14 nature Bedienungsanleitung

6.2. STOPPING

Z14 Manual Mode
To stop the machine when is operation, press the Stop button. The display will show a timer and the
message Stop. The machine will stop once the Cups have reached the vertical position. Once the
machine completely stops, the display will show again the number of fruits to squeeze.
Z14 Self-service Mode
Once you release the tap, the juicer will finish the cycle, so the cups stops at the initial correct upright
position, and the digital screen displays a "Clock icon and a Stop sign". Once the machine stops, the
screen will display an orange icon, indicating that the juicer is ready to squeeze again. The cups must
always be in an upright position.

6.3. COUNTER FUNCTION

The display stores the total number of cycles* completed. To visualize the figure, with the machine
stopped and in stand-by, press the STOP button. The figure will appear on the display for a few
seconds.
Bear in mind that all machines show a minimum of 200 to 250 cycles completed for quality control
testing.
*(cycle = complete set of movements to squeeze a piece of fruit)

6.4. SELECTOR LOCKING FUNCTION

In order to lock the SELECT button to avoid unwanted changes of the number of fruits to squeeze,
carry out the following operations:

Select the number on the display you wish to lock.

Press the button ON and wait until the machine stops.

Switch off the machine using the power switch.

Being the machine switched off, press and hold STOP.

Switch on the power keeping STOP button pressed for four seconds.

The display will show a four digits number.

Press the button SELECT (this button controls the two right digits) and press the button ON (this
button controls the two left digits) at the same time to select the number 7437.

Press STOP and the display will show - - - -

Turn off the machine using the power switch. If you fail to do this, the display will keep showing
the message - - - -

Switch on the machine. Now the SELECT button is locked and the display will show Lock.
To unlock the SELECT button, repeat exactly the same operation.
30