Teaching-In; Teaching-In To Homematic Devices - HomeMatic HM-Sec-SC-2 Montageanleitung

break. If the power drops too low when sending, the
respective error code is displayed again.

7.2 Teaching-in

Please read this entire section before starting
the teach-in procedure.
Before being able to use your device with
QIVICON, it has to be taught-in to your
QIVICON Home Base.
Therefore, please log-in to „My QIVICON" at
www.qivicon.com/login. There, please select
„Add device" and follow the instructions.
Important information regarding ESD
protection:
The shutter contact contains components that
are sensitive to electronic discharge. Before tou-
ching the shutter contact while the wall mount
has been removed it is recommended to take all
relevant measures to protect against electro-
static discharges. Therefore, you can ground
yourself e.g. with a grounding strap or touch a
grounded object.
46
To integrate the shutter contact into your HomeMa-
tic system and enable it to communicate with other
HomeMatic devices (e.g. HomeMatic Radiator Ther-
mostat), you must teach it in first. You can teach-in the
shutter contact directly to other HomeMatic devices or
to the HomeMatic Central Control Unit:

7.2.1 Teaching-in to HomeMatic devices

If you would like to teach-in the shutter contact to
one or more HomeMatic devices, you must put the
devices to be taught-in into teach-in mode and select
the required teach-in channel. To do this, proceed as
follows:
During teach-in, please make sure you maintain
a distance of at least 50 cm between the
devices.
• Activate the teach-in mode of your shutter
contact. To actuate teach-in mode on the shutter
contact, press the teach-in button with a pointed
object. The button is located at the rear of the
electronics unit. The device LED flashes orange.
47