HomeMatic HM-Sec-SC-2 Montageanleitung Seite 26

During teach-in, please make sure you maintain
a distance of at least 50 cm between the
HomeMatic devices and the Central Control
Unit.
To teach-in your device to the Central Control Unit,
proceed as follows:
• Open the „WebUI" user interface in your browser.
• Click the „Teach-in devices" button on the right-
hand side of the screen.
• To activate teach-in mode, click „BidCoS-RF
teach-in mode" in the next window.
• Teach-in mode remains activated for 60 seconds.
An information box shows how much teach-in
time remains.
• Meanwhile, please activate the teach-in mode of
the shutter contact to teach-in as well.
• To actuate teach-in mode on the shutter contact,
press the teach-in button with a pointed object.
The button is located at the rear of the electro-
nics unit. The device LED flashes orange.
50
• Abort with a short press of the teach button, the
device LED will then illuminate in red.
• After a short time, the newly taught-in device will
appear in the inbox of your software interface.
The button „Inbox (x new devices)" indicates
how many new devices have been taught-in
successfully.
• If required, you can teach-in additional devices
by repeating the steps described above for each
device.
• Now configure the newly taught-in devices in the
inbox as described in the next section.
Configuring newly taught-in devices
Once you have taught-in your shutter contact to the
HomeMatic Central Control Unit, it will be moved to
51