Kärcher MC 50 Handbuch Seite 54

WARNING
Risk of accident!
Prior to lifting the waste container, check if the bolts on the
left and right are correctly seated in the retainer. Lifting is
only permitted if the bolt is seated correctly!
 Check seating of the bolt on the left and right side.
1 INCORRECT: Bolt is not properly seated in the retainer
2 CORRECT: Bolt is safely seated in the retainer
7.8.6 Raise waste container
 Using the thin end of the lever, turn the valve clockwise
until it hits the stop.
 Pump with the lever to raise the container.
1 Lever
2 Valve
 Pull the carriage with the waste container/water tank
back by approximately 30 cm.
 Continue raising the container until the front end is at a
sufficient distance from the supporting surface.
 Fully pull back the carriage with the waste container/
water tank.
54
7.8.7 Attaching the waste container/water tank
 Use the reverse sequence to reinstall the waste con-
tainer on the unit.
 Turn the valve anticlockwise to lower the container.
7.9 Removing the sweeping system
 Swing the brush holder at the collecting carriage up-
wards and let it lock into place.
 Lower the brush.
 Turn off the appliance.
 Separate the couplings (arrows).
 Raise the brush manually and unhook the wire rope.
 Swing the safety pin forward and pull it out.
17
-
EN