Maintenance; Cleaning And Maintenance; Fig. 8 Method Of Installing/Uninstalling The Air-Supply And Suction Systems; Fig. 9 Cleaning The Condenser - Igloo GASTROLINE CUBE Bedienungsanleitung

5. MAINTENANCE

5.1. Cleaning and maintenance

All maintenance operations should be performed after the device has been disconnected from the power!
Protect the electrical system against damage or flooding.
Do not use a water jet for cleaning. Use only a damp cloth to clean the device.
Do not use any sharp objects to remove dirt!
While cleaning and maintaining the inside of the device, make sure you do not damage or remove the silicone
components (bumper pads) Fig. 5/13 (p. 15) that protect glass elements protect from slipping and ensure a
better grip.

Fig. 8 Method of installing/uninstalling the air-supply and suction systems

1 – Air supply (DO NOT BLOCK the vents!!!)
2 – Inner surface
3 – Suction (DO NOT BLOCK the vents!!!)
Do not use mechanical ways to accelerate defrosting!
It is recommended to take a break from using the device once a month in order to clean its interior, defrost the evaporator
in a natural way, clean the condenser and check the door seals (Gastroline Cube 0.6.)
The condenser unit should be maintained clean. Impurities hinder the
exchange of heat, causing among others, an increase in electricity con-
sumption and can cause damage to the unit compressor.
In order to clean the condenser unscrew sheet-metal screws and remo-
ve the wind machine. Clean the condenser lamellas using a soft brush
or paintbrush. In the case of intese dirt (clogging of lamellas) on the
condenser, it is recommended to use a vacuum cleaner or compressed
nitrogen to suck/blow out the dirt between the lamellas.
www.igloo.pl

Fig. 9 Cleaning the condenser

User manual GASTROLINE CUBE
en
17