Elektra Beckum KS 210 Betriebsanleitung Seite 26

Carbon brushes check and replacement
3
Worn carbon brushes are noticeable by
− irregular running of the motor;
− static in radio/TV while the motor is run-
ning;
− stopping of the motor.
To check or replace carbon brushes:
1. Unplug power cable.
2. Unscrew brush plug from motor frame with a
suitable screw driver.
In the illustration the replacement of the front
carbon brush is shown. The rear carbon brush is
located on the opposite side.
3. Pull carbon brushes out and check. Each car-
bon brush must be at least 6 mm long.
4. Put intact brushes into the brush holder. The two
lugs on the sides of the small metal plate must
fit into the grooves of the brush holder.
5. Replace the brush plugs.
6. Check the functioning of the saw.
Saw cleaning
• Remove chips and saw dust with brush or vac-
uum cleaner from:
− motor vent openings;
− hollow space under the turntable;
− setting devices;
− operating controls.
Also remove chips and saw dust from inside the
saw, if necessary.
Saw transportation
1. Swing sawhead down.
2. Push locking pin in.
3. Remove all accessories projecting over the saw
table.
If possible use original carton for shipping.
2.26
Saw storage
A
A
Service plan
Dust spout (when
working without dust
collection)
Guide elements for
6mm
saw setting
Safety devices:
− Retractable blade
− Safety lock
Power supply cable
Carbon brushes of
motor
Danger!
Store saw so that
− it can not be started by unauthorized per-
sons and
− nobody can get hurt by the stored
machine.
Caution! Do not store machine unprotected
outdoors or in damp environment.
Before switching on
Visual check if unob-
structed by chips.
Monthly (if used daily)
− Remove saw dust
− Apply light coat of
Check function.
guard
Check for damage, if
necessary have
replaced by a qualified
electrician.
Every 50 operating hours
Check, replace if nec-
essary.
with vacuum
cleaner or small
brush;
oil to guide ele-
ments.
KS 210 / KS 210 HM Plus