Gastroback 46016 Bedienungsanleitung Seite 54

Problem Possible Reasons
You cannot The appliance is not
switch on the live.
appliance.
The overheat protection
is active.
The bag or foil You have used impro-
melts or is rip- per foils or bags.
ped at the seal.
The sealing bar is too
hot during the sealing
process.
The sealing time is too
high.
The appliance may be
overheated.
The container is The vacuum hose is not
not evacuated connected properly.
(function CANI-
STER or MARI-
NATE).
The vacuum hose is
damaged.
The lid seal of the
vacuum container is
leaking.
54
The Easy Solution
Ensure that the power cord is undamaged and plugged in correctly at
the power supply and at the power socket of the appliance.
By connecting a lamp, ensure that the mains power outlet is live.
Unplug the appliance and wait for at least 20 minutes. Then try again.
Only use foils and bags suitable for foil sealing appliances.
Allow the unit to cool for 20 seconds between uses.
Reduce the sealing time (SEAL TIME).
Leave the appliance cool down for at least 20 minutes with the lid
open. After each sealing process, wait at least 20 seconds before
sealing the next bag.
Ensure that the correct end of the vacuum hose is inserted properly
into the vacuum outlet of the appliance.
Ensure that the connection of the vacuum hose on the vacuum port of
the container lid is airtight.
Contact your vendor for replacement.
Ensure that the lid seal of the container and the rim of the container
are completely clean. If required, replace the seal. Use another con-
tainer.