Wiring Diagram - GRAUPNER S.M.S. EMDEN Betriebsanleitung

Wiring diagram

Motor
Motor
to speed controller
Please test the model for nontilting. It should therefore
be completely assembled. Put it in a bathtub then by
tilting it to 45°. Should the boat not be able to right
itself, an additional weight unit (up to 500 g) must be
fixed to the hull under the accus. You can either use
lead strips, sheet steel or steel rods (see illustration).
When the position of the model is stable, the additional
weight unit must be glued without slipping.
Maiden run
Charge up all the batteries and test the model's working systems one by one. Check that all the parts which
are not permanently attached are firmly seated. Now you are ready for the boat's maiden run. Keep the
boat's speed low at first, and give yourself plenty of time to become familiar with its handling. The model is
fairly fast, and therefore needs to be operated on a large stretch of water. Don't allow the boat to get too far
away from the bank.
We hope you have many hours of pleasure running your S.M.S. Emden.
Replacement parts
Order No. 2010.6
You will also need the following items (not included in the set)
Order No. 4709
Order No. 2875
Order No. 2490.6
Order No. 2989
Order No. 3061
Order No. 3368.1
GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Keine Haftung für Druckfehler. Technische Änderungen vorbehalten! Liability for printing errors excluded. We reserve the right to introduce modifications. Sous réserve de
modifications! Nous ne sommes pas responsables d'éventuelles erreurs d'impression!
3061
Important Advice
Replacement propeller set
X-306 ECO-SPORT SYSTEM FM RC set
NAVY V40R speed controller
Drive battery: GM Power Pack 3600 6N-3600 NiMH 7.2V / 3.6 Ah (two required)
G2 connector system for connecting the speed controller and drive batteries
G2 parallel battery lead
Velcro tape
#0058124
speed controller
G2 plug
to receiver
Drive battery
Drive battery
3061
G2 plug
17
06/2007