GRAUPNER S.M.S. EMDEN Betriebsanleitung Seite 12

•
Never run the boat in adverse conditions, e.g. rain, storm, strong wind, choppy water or strong currents.
•
Read the instructions provided with your radio control system and accessories, and observe the
recommendations.
•
Before you run the model check that the radio control system is working reliably, and that all
connections are secure.
•
Dry batteries must never be recharged. Only batteries marked as "rechargeable" are safe to recharge.
•
Check the range of the radio control system before each session: ask a friend to walk about 100 m
away from the model carrying the transmitter. Your friend will be able to tell you whether all the working
functions operate correctly at this range.
•
Ensure that the frequency you intend to use is not already in use by other modellers. Never run your
boat if you are not certain that your channel is free.
•
Bear in mind that other radio equipment and transmitting stations can cause serious interference to the
model. Ensure that no equipment of this type is being used in the vicinity while you are operating the
model.
•
Do not carry out any work on the drive train unless you have disconnected and removed the battery.
•
When the drive battery is connected, keep well clear of the area around the propellers, and make sure
any spectators do the same.
•
Do not be tempted to exceed the recommended operating voltage. Higher voltages may cause the
motors or speed controller to overheat, and the electrical cables may even melt. If this should happen,
the model could easily be ruined.
•
Check that all the drive train components work smoothly and freely. This applies in particular when the
boat is running, as leaves and other debris may get caught in the power system components. The motor
and speed controller could then be ruined by overloading.
•
Dry cells and rechargeable batteries must never be short-circuited. Do not allow them to come into
direct contact with water.
•
Remove the rechargeable battery and the dry cells in the transmitter and receiver pack if the model is to
be transported, or will not be used for a long period.
•
Do not subject the model boat to high levels of humidity, heat, cold or dirt.
•
Secure the model and your RC equipment carefully when transporting them. They may be seriously
damaged if they are free to slide about.
•
Never operate the boat in moving water (e.g. a river), as its low speed may result in the model drifting
off downstream.
•
If you have to salvage the model, take care not to risk your own life or that of others.
•
Take particular care to ensure that the boat is completely watertight, as it will sink if too much water
enters the hull. Check the model for damage before every run, and ensure that water cannot penetrate
through the shaft bearings.
•
Allow the boat to dry out thoroughly after each session.
•
Be sure to check repeatedly during the first run that the shaft system is watertight. If water enters the
hull through the shaft tubes, remove the shafts and lubricate the tubes with plenty of grease, Order No.
570.
•
NOTE: the electric motors installed in the model must not be discarded in the household rubbish. When
they are worn out, they should be removed from the boat and taken to your local collection point for
electrical waste.
•
NOTE: if you wish to run the boat with parallel-wired drive batteries, they should only be inter-connected
while the model is operating, as the two packs could affect each other under no-load conditions, and
they might be damaged. Connect the batteries just before running the boat, and disconnect them again
immediately afterwards. On no account store the batteries connected by the parallel lead.
GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Keine Haftung für Druckfehler. Technische Änderungen vorbehalten! Liability for printing errors excluded. We reserve the right to introduce modifications. Sous réserve de
modifications! Nous ne sommes pas responsables d'éventuelles erreurs d'impression! #0058124
12
06/2007