GRAUPNER S.M.S. EMDEN Betriebsanleitung Seite 15

•
Remove the hatch over the rudder, and set the
rudder to the "straight ahead" position. The output
lever should now be fitted to the rudder servo,
exactly at right-angles to the pushrod. Tighten the
output screw to retain the output lever.
•
Attach Velcro (hook-and-loop) tape or double-
sided foam tape to the speed controller and the
receiver; install these components on the plywood
plate adjacent to the rudder servo.
•
Connect the rudder servo and the speed controller
to the receiver, and secure the cables neatly in the
hull using cable ties or Velcro tape.
•
Deploy the receiver aerial under the deck support
flange inside the hull, and tape it in place securely
(arrows). IMPORTANT:
reception, the aerial wire must be as high as
possible above the waterline, and should run in a
broad curve round the hull; the GRP material only
has a very slight adverse effect on radio reception.
If you prefer, you can install a vertical whip aerial
made of thin wire. If you do this, shorten the
flexible aerial attached to the receiver by the same
length as the whip, then solder the two together.
GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Keine Haftung für Druckfehler. Technische Änderungen vorbehalten! Liability for printing errors excluded. We reserve the right to introduce modifications. Sous réserve de
modifications! Nous ne sommes pas responsables d'éventuelles erreurs d'impression!
to ensure reliable
#0058124
15
06/2007