Configuring The Rs232 Interface; Setting The Unit Of Relative Humidity And Temperature - Novasina AW SPRINT Bedienungsanleitung

#06:Analog out.
submenu...
06:Ana. T out.
LO: -0.0•C
06:Ana. T out.
HI: 50.0•C
06:Ana. H out.
LO: 0.000aw
06:Ana. H out.
HI: 1.000aw
5.5 5.5 Configuring the RS232 inter Configuring the RS232 inter
5.5 5.5 5.5 Configuring the RS232 inter

Configuring the RS232 interface

Configuring the RS232 inter
#07:RS232 mode
PC ~Printer
07:RS232 mode
PC output
07:RS232 mode
Printer aut.
07:RS232 mode
Printer man.
5.6 5.6 5.6 5.6 5.6 Setting the unit of r Setting the unit of r Setting the unit of relative humidity and temperatur Setting the unit of r Setting the unit of r
#08:Humid. unit
~[aw] [%RH]
#09:Temp. unit
~[•C] [•F]
52
• Activate the menu mode and select main menu point "06".
• Call the submenu by pressing <Enter>. You can select the individual
submenu points one after the other by pressing the < > oder < > key.
– In the first menu point establish the lower limit value for the
temperature.
– In the second menu point establish the upper limit value for the
temperature.
– In the third menu point establish the lower limit value for the humid-
ity.
– In the fourth menu point establish the upper limit value for the
humidity.
face face
face face
• Activate the menu mode and select with the < > oder < > key the
main menu point "07" and press <Enter>.
• Now select with the < > oder < > key the desired configuration and
confirm with <Enter>:
– Data transfer to PC
– Automatic print out mode
As soon as in the analyzing mode the stability indicator lights up
(green LED "OK"), a "Stable" protocol is automatically printed out.
– Manual print out mode
After reaching stability, by pressing the <Stable> or <Actual> key
for at least 2 seconds, the corresponding protocol is printed out.
Note: for details on connecting peripheral equipment see chapter 8.
elative humidity and temperatur elative humidity and temperatur elative humidity and temperature e e e e elative humidity and temperatur
Selecting unit of relative humidity Selecting unit of relative humidity Selecting unit of relative humidity
Selecting unit of relative humidity Selecting unit of relative humidity
• Activate the menu mode and select main menu point 08 by pressing the
< > oder < > key.
In this main menu point you select whether the relative humidity is to be
displayed in "aw" or %RH in the standby mode.
Selecting temperature unit Selecting temperature unit
Selecting temperature unit Selecting temperature unit Selecting temperature unit
• Activate the menu mode and select main menu point 09 by pressing the
< > oder < > key.
In this main menu point you select whether the temperature is to be
displayed in "°C" or "°F" in the standby mode.
Note: Water activity is measured throughout the world as an aw value, and
the temperature is indicated in °C.