State Of Charge; Led On Charger; Assembling The Blower; Mounting, Adjusting And Removing The Nozzle - Stihl BGA 56 Gebrauchsanleitung

7 Assembling the Blower

1 LED glows red. Battery too hot or too cold.
4 LEDs flash red. Malfunction in battery.
If 3 LEDs glow red, the blower is too hot.
If 3 LEDs flash red, there is a malfunction in the blower.
► Troubleshooting, @ 17.

6.2.2 State of Charge

1
► Press the button (1).
The LEDs (5) glow green for about 5 seconds and indicate
the state of charge.
► If the LED on the right flashes green: Charge the battery,
@ 6.1.
6.3

LED on Charger

The LED indicates the operating status of the charger. LED
glows green or flashes red.
BGA 56
If the LED glows green and 1 LED on the battery glows red:
Battery is too hot or too cold.
► Troubleshooting, @ 17.
7
80-100%
7.1
60-80%
40-60%
20-40%
The nozzle can be mounted to the blower tube in three
positions to suit the height and reach of the user. The positions
are marked on the blower tube.
0-20%
► Switch off the blower, @ 9.2.
► Remove the battery, @ 8.2.
1
► Line up the lug (3) and the slot (2).
► Push nozzle (1) into required position on blower tube (4).
► Rotate nozzle (1) until it engages.
LED glows green and LEDs on battery glow or
flash green. Battery is being charged.
LED flashes red. No electrical contact between
battery and charger or malfunction in battery or
charger.
Assembling the Blower

Mounting, Adjusting and Removing the Nozzle

2
English
3
4
35