Cleaning Operations - Kärcher BR 47/35 ESC Handbuch

Tips for cleaning
First clear off loose, coarse dust manually.
–
Remove hard objects (such as stones)
–
from the ridges of the steps.
Clean the front side of the escalator
–
steps manually.
Clean the stepping areas in overlapping
–
strips. To do that, first move the appli-
ance from the working position and
place it on the side.
Observe the steps while cleaning. They
–
should be moist but not wet. There
should not be any foam residue.
First do moist cleaning (with detergent
–
liquid) and then dry (by setting the appli-
ance to dry vacuum cleaning).
Then clean using clear water so as to
–
remove detergent residues.

Cleaning operations

Danger
Risk of injury and electrical shock! Always lay
the extension cable in such a way that it does
not get jammed or crushed and also does not
cause somebody to stumble over it.
 Plug in the main plug.
 Insert the end of the extension cable as
a loop in the strain relief clamp.
 Lock the rear wheels.
 Place the machine on the platform in
such a way that the front wheels do not
touch the first step of the moving travel-
lator/ escalator.
 Press pedal for lowering the brush
head. The brush head will be lowered
and the lock lever will arrest in its posi-
tion.
 Press the foot pedal with one foot and
while doing so move the machine a little
back and forth towards the side. The
machine will position itself centrally in
the grooves of the steps; you will then
hear a rustling sound.
Danger
Risk of injury! Do not push the appliance
onto the escalator any further than the indi-
cations given below. Otherwise, the ma-
chine will get dragged off by the escalator.
In case of danger, immediately press the
emergency stop switch of the escalator.
The cleaning head must lie flat on the esca-
lator.
 Set the appliance switch to regular or
basic cleaning.
The machine is started.
Note
The machine switches off when the dirt wa-
ter reservoir is full. To restart the machine,
empty the dirt water reservoir and briefly
set the appliance switch to "0".
 Continue cleaning until the travellator/
escalator has completed 1 or 2 rounds.
Then move the machine towards the
side and start a new cleaning process.
– 5
EN 21