Floor Cleaning - Kärcher FR Classic Bedienungsanleitung

Install/remove/replace the high
pressure nozzles
 Loosen the safety clamp with a screw-
driver.
 Remove the protective grid.
 Install / replace the high pressure noz-
zles.
 Mount the protective grid on the pin.
 Push the safety clamp in until it locks.

Floor cleaning

Mount the spray lance
 Connect the spray pipe of the high pres-
sure cleaner to the FR Classic and
tighten it with a wrench (width 24).
6
Install the spray pipe on high
pressure cleaner K6. or K7.
1 Hand spray gun with bayonet connec-
tion
2 Steel pipe extension 0.5 m (order no.
4.760-558.0 or steel pipe extension 0.9
to 1.7 m (order no. 2.639-722.0)
3 Adapter (order no. 4.762-402.0)
4 FR Classic
 Connect the components with one an-
other as shown above.
 Guide the surface cleaner so that it re-
mains close to the surface to be
cleaned.
ATTENTION
Do not run over protruding corners!
The surface cleaner is not suitable for
scouring or scrubbing!
Outdoor surfaces should be swept before
the surface cleaner is used to avoid damag-
ing the high-pressure nozzles.
– 2
EN
Application