Floor Cleaning - Kärcher FRV 30 Originalbetriebsanleitung

Assemble nozzle packet
Figure 2, see cover page
1 O ring
2 Rotation arm
3 Nozzle
4 Union joint
 Inser the O ring in the nut of the rotation
arm.
 Place the nozzle on it.
 Slightly fasten the nozzle with the Union
joint.
Note:
The exit jet must be directed parallel to the
rotation arm.
Figure 3, see cover page
 Adjust the wrench area of the nozzle
(width 10) so that it is parallel to the ro-
tation arm.
 Tighten the Union joint (width 22) using
a wrench.
 Repeat the process on the second rota-
tion arm.
Figure 4, see cover page
1 Injector nozzle
2 Wrench
 Screw the injector nozzle into the injec-
tor using the wrench and tighten it fin-
gertight (8 Nm).
The wrench is included with the nozzle
set.

Floor cleaning

Figure 5, see cover page
 Connect the steel pipe of the high pres-
sure cleaner to the surface cleaner and
tighten it with a wrench (opening width
24).
CAUTION
A strong wastewater jet will emerge from
the hose connection. Do not use the sur-
face cleaner without a hose.
 Insert the hose into the hose connection
and secure by rotating.
 Route the other end of the hose to a
drain.
Note:
The free end of the hose can be attached
by means of the included Velcro tape (e.g.
on a drain grid).
 Hold the hand spray gun and the spray
pipe firmly with both hands.
 Guide the surface cleaner so that it re-
mains close to the surface to be
cleaned.
Wall cleaning
Figure 6, see cover page
1 Connectiing piece
2 Screw
 Place the connecting piece vertically.
 Turn in the enclosed screw in order to
hold the joint firmly.
Figure 7, see cover page
1 Adapter (order no.: 4.111-022.0)
2 Hand spray gun
 Screw the adapter to the connection
and tighten it with a wrench (key width
22).
 Screw the hand spray gun on the adapt-
er, align it and tighten it with a wrench
(key width 27).
Figure 8, see cover page
CAUTION
A strong wastewater jet will emerge from
the hose connection. Do not use the sur-
face cleaner without a hose.
 Insert the hose into the hose connection
and secure by rotating.
 Route the other end of the hose to a
drain.
 Hold the appliance at the handle while
cleaning the wall.
 Guide the surface cleaner so that it re-
mains close to the surface to be
cleaned.
– 2
EN 7