Matrix 310.550.320 Originalbetriebsanleitung Seite 45

Should the tool become wet, wait until it is
completely dry before you use it again.
Before starting work, it is recommended to check
the objects to be cut for possible foreign objects
and to remove them. When despite of this you
encounter a foreign object during cutting, switch
off the tool and remove this object.
If the tool is jammed by a foreign object (stones,
piles of grass), switch it off, and remove the
object using a blunt item. Never use your fingers
to remove jammed foreign objects, because this
may cause serious injuries.
Always keep the running tool away from your
body.
Attention: the cutting tool still runs for some time
after the tool is switched off!
Do not overload the engine, and do not use it for
work the tool is not designed for.
Always make sure the ventilation openings are
free of dirt.
Store the tool out of the reach of children.
Store the tool at a safe and dry location.
Check the engine for damages after impact, or
other damages.
Keep body parts and pieces of clothing away
from the trimmer head when you start the
engine, or keep it running.
Always keep in mind that especially during
trimming of lawn edges, gravel enclosures, and
similar locations stone and dirt can be hurled
away from the cutting line.
Never cross roads or paths when the tool is
switched on.
Never cut against hard objects such as stone, etc.
This way you avoid injuries, and damages to the
tool.
Never use the tool without the guards attached.
Never use your hands to stop the cutting device.
Always wait until it stops on its own.
Hold and guide the trimmer head as close to the
ground as possible.
Only cut grass growing on the ground. Do not
cut grass in cracks in walls, growing or on rocks,
etc.
Always make sure no objects, or other debris is
collecting in the trimmer head, in the protective
hood, or in the engine.
Only use the tool, when the guard is attached.
Always switch off the tool, before you put it
down.
Keep in mind that there is risk of injuries in the
area of the cutting device intended to cut off the
line.
CAUTION: The cutting tool continues rotating for
a few seconds after the engine is turned off.
Put the tool down only after the cutting tool has
completely stopped and the motor is turned off.
When the cutting tool is damaged, it must be
replaced at once.
Always use the original line only. Never use a
metal wire instead of the nylon line.
Tool and cutting tools must be properly
inspected and serviced periodically. Damages
must be repaired by a service center.
Only use accessories recommended by the
manufacturer.
45