Working With Trimmer - Matrix 310.550.320 Originalbetriebsanleitung

Starting a warm engine
- Corresponding to the process as when the engine is cold. Choke lever is always here in the "ON"
( ) position.
ON
A19

6 Working with Trimmer

- When you work with the petrol brush cutter
for the first time, familiarize yourself with the
operation and control of the petrol cutting blade
without running engine.
- The design of the petrol brush cutter allows for
operation only at the right side of the user's body.
- Keep the petrol brush cutter firmly with both
hands on the handles.
- Always make sure that the cutting tool
continues to rotate briefly after the throttle has
been released.
- Always so that the cutting tool no longer turns
in a proper engine idle not press down the
throttle.
- Always work with high speed so you have the
best cutting results.
- Poke when working on a stone or a tree, turn off
the engine
and remove the spark plug then examine the
petrol brush cutter for damage.
Caution: Always be extra careful when working in
difficult terrain and slopes.
Cut tall grass gradually so as not to overload the
62
Once the unit is running, the choke lever (24) can
be returned to the "ON" (
Switching off:
- Allow the engine to return to idle speed.
Set the stop/start switch (3) on the control handle
in the off position "O".
24
Attention. The cutter rotates after the engine off
for a few seconds. Hold both handles firmly to a
complete stop the cutting device.
unit.
Always wear safety glasses and hearing
protection and a safety helmet.
6.1 Mowing with nylon head
-The petrol cutting blade is delivered with a filled
line cassette.
-This line will wear out during work. To feed new
line, forcefully press the head of the line cassette
onto the ground while the engine is running at
working speed.
-The line is automatically fed due to centrifugal
force.
-The knife at the line guard will shorten the
trimming line to the correct length.
- Run the trim line approach cautiously to an
obstacle and cut with the tip of the line around
the obstacle.
6.2 Mowing brush cutting
- Use the cutting blade to comb through
brushwood, rank growth, young tree populations
(trunk diameter of maximum 2 cm), and high
grass.
)position.