Speed Regulation - ProMed Feeling Gebrauchsanleitung

O
PERATING THE UNIT
DE
E. Speed Regulation
Move the on/off switch (B) from "off-(O)" position to I position,
EN
to start the manicure. You can further increase the speed by
pushing the switch in the same direction at stage II.
FR
F. Before using the device for the first time, allow the hand piece to
run for approx. 30 minutes with approx. 7,000 U/Min (switch
IT
position I). This is necessary so that the motor brushes can be
grounded.
ES
NL
Note:
A different running noise between clockwise and counter-
RU
clockwise rotation is normal and caused by bedding in of the
carbon brushes or by running in of bearings.
PL
SE
FI
In cases of malfunctioning:
• Check that the power supply is correct.
• Check whether the LED (D) lights red
• Please check whether the rotation direction switch is in the
centre position (Standby).
• If the problems have still not been solved after following these
steps, please consult your service center immediately.