Power Management - Comfee SOGNIDORO-09E Bedienungsanleitung

Operation
-Keep windows and doors closed for the best
dehumidifying effect.
-Do not put the duct to window.
AUTO operation
-When you set the air conditioner in AUTO mode, it will
automatically select cooling, heating(cooling only models
without), or fan only operation depending on what
temperature you have selected and the room temperature.
-The air conditioner will control room temperature
automatically round the temperature point set by you.
-Under AUTO mode, you can not select the fan speed.
NOTE: Under AUTO mode, both the AUTO mode and the
actual operation mode indicator lights illuminate for the
unti with

POWER MANAGEMENT

FAN operation
-Press the "MODE" button until the"FAN " indicator light
comes on.
-Press the "FAN SPEED" button to choose the fan speed.
The temperature can not be adjusted.
-Do not put the duct to window.
TIMER operation
-When the unit is on, press the Timer button will initiate
the Auto-off stop program, the TIMER OFF indicator light
feature.
illuminates. Press the UP or DOWN button to select the
desired time. Press the TIMER button again within 5
seconds, the Auto-on start program is initiated. And the
TIMER ON indicator light illuminates. Press the up or down
button to select the desired Auto-on start time.
-When the unit is off, press the Timer button to initiate the
Auto-on start program, press it again within five seconds
will initiate the Auto-off stop program.
-Press or hold the UP or DOWN button to change the Auto
time by 0.5 hour increments, up to 10 hours, then at 1 hour
increments up to 24 hours. The control will count down the
time remaining until start.
-The system will automatically revert back to display the
previous temperature setting if there is no operation in a 5
seconds period.
-Turning the unit ON or OFF at any time or adjusting the
timer setting to 0.0 will cancel the Auto Start/Stop timer
program.
-When the malfunctionoccurs, the Auto Start/Stop timed
program will also be cancelled.
SLEEP/ECO operation
-Press this button, the selected temperature will increase
(cooling) or decrease(heating) by 1°C/2°F(or 1°F) 30
14