Up And Down Buttons; Power Button; Led Display - Comfee RG57H/BGE Bedienungsanleitung

Operation
MODE button
Selects the appropriate operating mode.
Each time you press the button, a mode
is selected in a sequence that goes from
COOL, FAN and DRY .The mode indicator
light illuminates under the different mode
setting.
NOTE: On above modes, the unit operates
the auto fan speed automatically. You can
set fan speed only by the remote controller
on COOL and FAN modes.
Up (+) and Down (-) buttons
Used to adjust (increasing/decreasing)
temperature settings in 1°C/2°F(or 1°F)
increments in a range of 17°C/62°F to
30°C/88°F (or 86°F).
NOTE: The control is capable of displaying
temperature in degrees Fahrenheit or
degrees Celsius. To convert from one to
the other, press and hold the Up and Down
buttons at the same time for 3 seconds.

Power button

Power switch on/off.

LED display

Shows the set temperature while on cool mode.
While on DRY and FAN modes, it shows the
Power
indicator light
room temperature.
Shows Error codes:
Timer mode
E1-Room temperature sensor error.
indicator
light (set only by
E2-Evaporator temperature sensor error.
remote controller)
E4-Display panel communication error.
EC-Refrigerant leakage detection malfunction
(on some models).
Shows protection code:
P1-Bottom tray is full--Connect the drain hose
and drain the collected water away.If protection
repeats,call for service.
Note: When one of the above malfunctions
occurs, turn off the unit, and check for any
obstructions. Restart the unit, if the malfunction is
still present, turn off the unit and unplug the
power cord. Contact the manufacturer or its
service agents or a similar qualified person for
service.
Exhaust hose installation
The exhaust hose and adaptor must be installed or
removed in accordance with the usage mode.
For COOL mode must be installed exhaust hose.
For FAN or DRY mode must be removed exhaust
hose.
Operation Instructions
COOL operation
-Press the "MODE" button until the "COOL" indicator light
comes on.
-Press the ADJUST buttons "+" or "-" to select your desired
room temperature. The temperature can be set within a
range of 17°C~30°C/62°F~88°F(or 86°F).
-Press the "FAN SPEED" button on the remote cotroller to
choose the fan speed.
DRY operation
-Press the "MODE" button until the "DRY" indicator light
comes on.
-Under this mode, you cannot select a fan speed or adjust
the temperature. The fan motor operates at LOW speed.
-Keep windows and doors closed for the best dehumidifying
effect.
-Do not put the duct to window.
FAN operation
-Press the "MODE" button until the"FAN " indicator light
comes on.
-Press the "FAN SPEED" button on the remote cotrollerto
choose the fan speed. The temperature can not be
adjusted.
-Do not put the duct to window.
13
EN