Air Flow Direction Adjustment - Comfee SOGNIDORO-09E Bedienungsanleitung

Operation
minutes.The temperature will then increase (cooling) or
decrease (heating) by another 1°C/2°F(or 1°F) after an
additional 30 minutes. This new temperature will be
maintained for 7 hours before it returns to the originally
selected temperature. This ends the Sleep/Eco mode and
the unit will continue to operate as originally programmed.
NOTE: This feature is unavailabe under FAN or DRY
mode.
Other features
FOLLOW ME/TEMP SENSING feature(optional)
NOTE:This feature can be activated from the remote
control ONLY. The remote control servesas a remote
thermostat allowing for the precise temperature control at
its location. To activate the Follow Me/Temp Sensing
feature, point the remote control towards the unit and
press the Follow Me/Temp Sensing button. The remote
display is actual temperature at its location. The remote
control will send this signal to the air conditioner every 3
minutes interval until press the Follow Me/Temp Sensing
button again. If the unit does not receive the
Follow Me/Temp Sensing signal during any 7 minutes
interval, the unit will exit the Follow Me/Temp Sensing
mode. NOTE: This feature is unavailabe under FAN or
DRY mode.
AUTO-RESTART(on some models)
If the unit breaks off unexpectedly due to the power cut,it
will restart with the previous function setting automatically
when the power resumes.
WAIT 3 MINUTES BEFORE RESUMING OPERATION
After the unit has stopped, it can not be restarted operation
in the first 3 minutes. This is to protect the unit. Operation
will automatically start after 3 minutes.

AIR FLOW DIRECTION ADJUSTMENT

The louver can be adjusted automatically. Adjust the air flow
direction automatically :(NOTE:On some models the louver
can be adjusted manually only)
-When the Power is ON, the louver opens fully.
-Press the SWING button on the panel or remote controller
to initiate the Auto swing feature. The louver willl swing up
and down automatically.
-Please do not adjust the louver manually.
POWER MANAGEMENT feature(optional)
When the ambient temperature is lower than the setting
temperature for a period of time, the unit will be
automatically operate power management feature. The
compressor and fan motor stop. When the ambient
temperature is higher than the setting temperature, the unit
will be automatically quit the power management feature.
The compressor and (or) fan motor run.
15