Plugging In And Ironing; Steam Ironing - Silvercrest SDBS 2800 A1 Bedienungsanleitung

Plugging in and ironing

Dry ironing without steam is possible at all tem-
peratures, steam ironing is only possible in the red
setting range on the temperature control
■ Insert the plug into a mains socket.
CAUTION! PROPERTY DAMAGE!
► If the clothing care instructions forbid ironing,
( symbol), the clothing item may not be
ironed. Ignoring this warning could lead to
permanent damage to the clothing item.
■ Check the care instructions on the labels in gar-
ments to see if they are suitable for ironing, and
at which temperature setting.
Tempera-
Type of
ture control
material
symbol
MIN
acrylic, rayon
Silk, wool,
polyester mix
MAX
■ Select the appropriate temperature setting using
the temperature control
SDBS 2800 A1
Control
lamp
Type of
material
The appliance does
not heat up
Nylon,
NYLON
SILK/WOOL
fabrics
Cotton,
COTTON
viscose
Linen
LINEN
.
NOTE
While it is heating up, always place the iron on
its base .
.
If you place the iron down on its sole
not move it, the automatic switch-off will be acti-
vated after 30 seconds (see chapter "Automatic
switch-off") and the appliance stops heating.
The control lamp
flashing. As soon as set temperature has been
reached, the control lamp
type lights up permanently and you hear a beep.
■ Wait until the control lamp
type lights up permanently and you hear a
beep. You can start ironing.
■ To dampen the laundry, press the spray button
. Water is sprayed from the water jet
This function is suitable for very dry and heavily
crumpled garments.

Steam ironing

■ Press the steam quantity button
until the desired steam quantity is set.
Steam level
1
2
3
■ The temperature control
least the red setting range
steam will be produced.
and do
for the set material type starts
for the set material
for the set material
repeatedly
Type of material
no steam
little steam
medium steam
lots of steam
must be set to at
. Otherwise no
GB│MT
│
.
19 ■