Before First Use; Filling The Water Tank - Silvercrest SDBS 2800 A1 Bedienungsanleitung

Before first use
■ Remove the steam iron from the packaging.
■ Remove all stickers and protective films from the
steam iron and the sole of the iron
RISK OF SUFFOCATION!
► Plastic bags can be dangerous. To avoid fa-
talities through suffocation, keep plastic bags
out of the reach of children.
■ Fill the water tank with water (See the chapter

"Filling the water tank").

■ Insert the plug into a mains power socket supply-
ing an electrical current as detailed on the rating
plate.
■ Move the temperature control
position.
■ Wait for the iron to heat up until you hear a
beep.
■ Pick up the iron and press the steam blast button
a few times so that steam comes out of
the sole of the iron
■ Then iron over a piece of old piece of material
to remove any residues that may remain on the
sole of the iron .
■ 18
│ GB│MT
.
to the "MAX"
.
Filling the water tank
■ Hold the iron in your hand at an angle.
■ Open the cover of the filler opening for the
water tank . This is marked with
■ Use the measuring beaker
distilled water to the water tank up to no more
than the "MAX" marking that you can see
through the filler opening to the water tank
■ Close the cover of the filler opening for the
water tank .
NOTE
If the mains water in your location is rated as
hard, it is recommended that you mix the mains
water with some distilled water. Otherwise, the
jets for the steam blast function could become
blocked with limescale prematurely.
To extend the optimal steam blast function, mix
mains water with distilled water according to the
table:
Water hardness
very soft/soft
medium
hard
very hard
Ask your local water utility about the water hard-
ness in your area.
.
to add tap water/
.
Ratio of distilled
water to
tap water
0
1:1
2:1
3:1
SDBS 2800 A1