Ace instruments ALP-1 med Bedienungsanleitung Seite 12

Only the usage of original ACE mouthpieces...
Guarantees test result accuracy
Guarantees 100 % hygenity
Guarantees full warranty of this device
ACE INSTRUMENTS ADVISES: EVEN IF YOU GET A RESULT MEANING "SAFE
RANGE", YOU SHOULD NEVER DRIVE AFTER CONSUMING ALCOHOL OR DO ANY
OTHER ACTIVITIES THAT ARE SEVERELY IMPAIRED BY ALCOHOL CONSUMPTION
AND MIGHT ENDANGER YOUR HEALTH AND SAFETY OR THE HEALTH AND SAFETY
OF OTHERS.
Display indications:
If you see "FLOW" on the display, the breath sample
FLOW
was not strong enough for a measurement. Please
wait until you can see "BLOW" on the display again
and then make sure that the breath is strong and
steady during the sampling.
If you see this on the dirplay then the battery power
Battery Change
is low, please replace the batteries with 2 new ones.
This message is shown 6 months after the last
Service required
calibration or by setting CAL required number.
Calibration
Number of tests after a calibration (memorized in
C. Test No
the sensor module).
Number of tests after a calibration (memorized in
T. total
the device).
Error with sensor module, please replace the sensor
Sensor empty
with a new one.
Check to connect system
Error because of critical temperature during usage,
Over Temperature
the device must not be used under -5ºC.
Keep the operating
temperature range
Condensor charging error, please contact
System Error 1
ACE customer service.
Service required device
Sensor leakage, please contact ACE customer
Sensor empty
service.
Check to connect system