Factory Settings; Operation - Configuring The Terminals; Incoming Calls; Outgoing Calls - Auerswald VoIP/ISDN Installations- Und Bedienungshandbuch

Factory settings

Using this function you can reset the device to its
original factory state. The device will then restart
itself.

Incoming calls

In order to accept incoming calls it is necessary to
configure the telephone system or ISDN tele-
phone that is connected.
The procedure for programming is similar to set-
ting up an ISDN multi-point connection.
The VoIP/ISDN Gateway sends all recognized
calls with the registered call number to the con-
nected device.
For this, all call numbers stored in the SIP
accounts are registered in the telephone system
as „Exchange numbers". The calls are then distrib-
uted according to the internal assignment in the
telephone system as if it were an ISDN multi-point
connection.
If you are using ISDN telephones, enter the SIP
account call numbers into the telephone as
„MSNs".
Due to the large variety of terminals
found on the market we cannot provide
any information on operation. In this
case we refer you to the operating instructions of
the particular terminal.

Outgoing calls

To make outgoing calls with the VoIP/ISDN Gate-
way it is also necessary to configure the device.
The assignment of the SIP account that is to be
used depends on the outgoing call number of the
telephone system or ISDN telephone that was
sent.
Set up your telephone system for outgoing calls so
that the call number of the desired SIP account is
sent to the VoIP/ISDN Gateway.
Operation – Configuring the terminals
Note that you will probably be unable to
reach the device with the current IP
address once you have done this. Use a
telephone to query the IP address.
39
Configuration