Technical Data - Auerswald VoIP/ISDN Installations- Und Bedienungshandbuch

28

Technical Data

5. Once you hear a positive audio signal, hang
up.
6. If the sub-network mask has to be changed, lift
the telephone receiver again.
Enter ##*942*0000* and then the sub-network
mask in the format nnn*nnn*nnn*nnn#.
Example 255.255.255.0:
##*942*0000*255*255*255*000#.
7. Once you hear a positive audio signal, hang
up.
Data
Display IP address
Enter IP address
Display net mask
Enter network mask
Reset to factory
settings
Power Supply
Nominal voltage 230 V
for plug-in power supply
Type number of
plug-in power supply FE48/30
Power consumption: 6 W max (idle mode)
S bus voltage 40 V + 5/-15%; 4 W max
0
Temperature Range
Operational +0...+40°C, protect against
temperature direct sunshine!
Transportation and
storage temperature -20...+70°C
humidity 10 - 75%, non condensing
Code Input data
##*941# none
##*941*0000* nnn*nnn*nnn*nnn#
##*942# none
##*942*0000* nnn*nnn*nnn*nnn#
##*98*0000# none
Technical Data
10%, 50 Hz
8. This concludes initial configuration.
After changing the setting, the VoIP/
ISDN Gateway confirms the successful
input with an affirmative audio signal.
Applying the change generally takes about 30-60
seconds.
In order to display the IP address or sub-network
mask (see table), your ISDN telephone must be
able to show DISPLAY notifications.
Notes
IP address is displayed on the
ISDN telephone.
Input is confirmed acoustically.
Network mask displayed on ISDN
telephone.
Input is confirmed acoustically.
The device is reset to the state in
which it was delivered.
Interfaces
Ethernet connection: 10/100 MBit/s,
Western jack RJ-45 (8/8),
automatic crossover detection
ISDN connection (S01): NT-simulation, PTMP or PTP,
Western jack RJ-45
Synchronisation
connection (S02): PTMP or PTP, Western jack RJ-45
Miscellaneous
Case plastic, light grey
Dimensions 174 x 174 x 36 mm (W x D x H)
Weight app. 390 g (without plug-in power
supply),
plug-in power supply app. 570 g
Safety CE