Internet Telephony - Setting Up/Changing An Sip Provider - Auerswald VoIP/ISDN Installations- Und Bedienungshandbuch

Displayed name:
In the case of some providers/devices the name of
the person you are calling is shown instead of the
call number.
Username/SIP-ID, Password, Authentication:
Please refer to the user registration information
provided by your SIP provider.
The input fields for Displayed name,
User name/SIP-ID, and Authentication in
our experience are called different
names depending on the provider. Often the
authentication input is dropped altogether.
After choosing a default provider, the input fields
for „Displayed name", „User name/SIP-ID", and
„Authentication" are labelled in the same way they
are found in the provider's registration documenta-
tion. This should simplify the input of settings.
Call number 1:
Enter the call number of your SIP account. Also
enter this number in the connected ISDN unit.
The entered ISDN call number is used as follows:
If you would like to make an outgoing VoIP call
using the ISDN device, the SIP account is chosen
using the phone's own ISDN call number. Then the
VoIP connection is established.
Note: Alternatively you can also choose an SIP
account for outgoing VoIP calls using the specific
SIP account dialling code found on the overview
page. This function is dependent on the attached
ISDN-System usable.
With an incoming VoIP call, the registered phone
number is used for an SIP account in order to call
the connected ISDN device.
Internet Telephony – Setting up/changing an SIP provider
On this page you can create SIP providers your-
self. If you would like to communicate via a SIP
server in your local network, you also create an
SIP provider. The number of providers is limited to
20.
If you would like to save changes for a provider,
press the „Apply" button.
„Reset" will restore the last settings that were
changed as long as these have not yet been trans-
mitted to the device.
You can enter up to ten call numbers if
necessary. By checking the „Additional
call numbers" field, you can make other
input fields visible. The first call number is always
transmitted for outgoing calls.
If you have entered multiple phone numbers for an
SIP account and the provider does not register call
numbers for VoIP calls, only the terminal with the
first call number is called.
Voice compression:
Adjust the desired compression of voice data with
this setting. Please note that the voice quality can
deteriorate. In addition, the compression you have
selected has to be supported by the Internet
telephony provider and by the terminal.
Registration interval:
The registration interval is the span of time that
passes until the device re-registers with your Inter-
net telephony provider.
If you have a DSL provider that performs a forced
disconnect once a day and your DSL modem
assigns a new IP address, you should enter a
small value for the registration interval. In the time
between the forced disconnect and a new registra-
tion it is possible that you cannot be reached by
VoIP and that you cannot make any VoIP calls.
Overview of settings for the selected provider:
If you click on the „More" view at the upper right of
the menu bar, the current settings for the provider
are displayed.
The settings for user-defined SIP providers can be
changed under „Internet telephony/SIP provider".
The parameters for a default SIP provider cannot
be changed. In this case, create a new SIP pro-
vider and make the desired changes.
A change to provider data is applied
immediately to the SIP accounts that use
this provider. Depending on the change
that has been made, the device will automatically
log off from the providers and will re-register itself
with the new settings. Voice connections in
progress are terminated.
35
Configuration