Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Mounting and Installation
Warning:
Touching the voltage carrying con-
ductors or connectors may be danger-
ous to life.
- Use the unit mounted on the wall only.
Warning:
Surge voltages like generated by a
thunderstorm, may lead to a danger-
ous electric shock.
- Therefore do not install the device during a
thunderstorm.
Warning:
Liquids entering the case may cause a
dangerous electric shock or may dam-
age or destroy the device.
- Pay attention when selecting the installation
location to prevent liquids from entering the
case.
- Use the device on dry rooms only
- Pay attention to the humidity conditions in
the technical data.
- Protect the device against spray water and
dust.
Warning:
High temperature may overheat the
device and may damage the device.
- Pay attention to the temperature conditions
in the technical data.
- Protect the device against direct sunshine.
Please observe the following advice
when selecting the mounting location:
- Near the installation location you are in need of
an unobstructed 230 volt mains plug with pro-
tective earthing for the power supply. Please
make sure that the mains plug is properly con-
nected (according to electric safety regulations).
- For connecting to the available network the
Router (Switch) should be next to the VoIP/ISDN
Gateway (the length of the Ethernet cable is
1,5 m).
- The connected PBX must be next to the VoIP/
ISDN Gateway in order to avoid long transmis-
sion ways between both devices (the length of
Mounting the Case to the Wall
Mounting and Installation
The following sequence must be observed when
installing the VoIP/ISDN Gateway:
1. Wall installation of the VoIP/ISDN Gateway
(page
29)
2. Connecting the terminal (ISDN PBX/ISDN tel-
ephone;
page
30)
3. Connecting the VoIP/ISDN Gateway to the
available network
4. Connecting the VoIP/ISDN Gateway to the
230 V mains network
5. Configuration of the VoIP/ISDN Gateway
(page
33)
the ISDN cable is 2 m). If it is not possible, a fixed
wiring (S
bus) between both units will be neces-
0
sary.
- Please avoid mechanical stress (e.g. vibrations)
and the close neighbourhood to devices that
radiate electromagnetic fields or interfere with
these units (e.g. radios, HAM-radio installations,
mobile telephones, DECT base stations, etc.).
Mount the case to the wall:
1. Mark the two drill holes on the wall. The
required distance between screws is 118 mm.
2. Drill the holes with a diameter of 6 mm and
insert the dowels.
3. Screw the screws in until the screw head has
a distance of app. 3 mm to the wall.
4. Put the case on the screws and pull it down-
wards on the wall until it stopps.
(page
30)
(page
30)
29
Werbung
Inhaltsverzeichnis
Fehlerbehebung
