Introduction; Security Advice - Auerswald VoIP/ISDN Installations- Und Bedienungshandbuch

Dear customers!

Introduction

This manual here describes the use, installation
and configuration of the VoIP/ISDN Gateway in
detail. Before starting with the installation, please
read the following security advice.
Pay attention to the following general se-
curity advice:
- Read the user manual and keep it for reference.
- The device described in this manual is made for
the indicated use only. If you are not sure about
the intended purpose of the product, please
contact your dealer.
- Pay attention to the limitation stated in the tech-
nical data. Exceeding these limitations (even if
for a short time) may cause considerable dam-
age.
- Pay attention to the relevant standards when
using 230 Volt power supply and units operating
on the power supply.
- Repairs should only be done by your author-
ized dealer. Contact your authorized dealer or
the manufacturer if necessary.
Improper use or exchange of the wall-
mount power supply may be danger-
ous to life or may damage or destroy the
device:
- Use only the enclosed plug-in power supply
unit (type number FE48/30).
- Make sure, the plug is inserted securely into
the wall mains outlet. Loose plugs or damaged
outlets are a fire hazard.
- Do not pull at the cable of the plug-in power
supply. Pull at the wall-mount power supply
itself If you want to switch off the device power.
- In case of damage to the plug-in power sup-
ply: Interrupt the mains power of the house
first before pulling the plug of the wall-mount
power supply.
Touching the voltage carrying conduc-
tors may be dangerous to life.
- Use the unit mounted on the wall only.
- When using tools at live circuits, pay attention to
sufficient isolation.
this manual.

Security Advice

- Pay attention when selecting the installation
location and when cleaning the case to prevent
liquids from entering the case.
self may be dangerous to life.
- In the event of a malfunction, the power cable
must be removed from the socket. The ISDN
connector cable and the network cable must also
be removed.
- Lay the connecting cables carefully to avoid any
danger of tripping. The connecting cables must
not be subjected to excessive pulling or bending
or mechanical loading. The connector cables
may only be laid inside the walls of a building.
- The mains cables of the electric devices and the
connection cables have to be checked regularly
for damages and to be exchanged in case of
damages.
- Replace damaged components (e.g. compo-
nents of the case) immediately.
- Use original components only. Otherwise the
device may be damaged or security and EMC
regulations may be violated.
- Therefore do not install the device during a
thunderstorm. Also do not work on cable con-
nections during a thunderstorm.
Introduction
Pay attention to the information in the ad-
ditional brochure „Guarantee declara-
tion, information service" in addition to
Liquids entering the case may cause a
dangerous electric shock or may dam-
age or destroy the device.
Touching a defective connection ca-
ble may be dangerous to life. Also any
damages of the case and of the device it-
Surge voltages like generated by a thun-
derstorm, may lead to a dangerous
electric shock.
25