Cleaning The Espresso Sieves, Sieve Holder And Espresso Outlet - Silvercrest SEMM 1470 A1 Bedienungsanleitung

Cleaning the espresso sieves, sieve holder and
espresso outlet
Remove all used powder from the espresso sieves
ration.
Clean the espresso sieves
regularly.
1) After you have prepared espresso/cappuccino/latte macchiato and removed
the sieve holder
–
Fix the espresso sieve in place by flipping the sieve blocker
and holding it in place.
–
Knock the espresso powder out of the espresso sieve
–
Flip the sieve blocker
–
Remove the espresso sieve
–
Clean the espresso sieve
with a little mild washing-up liquid. Rinse all the parts off afterwards
using clean water.
NOTE
► The espresso sieves
2) Replace the sieve holder
3) Fill the water tank
4) Place a suitably large, empty container onto the drip grille
5) Switch the appliance on using the on/off switch
lamps light up permanently.
6) Press the "Small" espresso button
outlet
the espresso outlet
NOTE
► If you want to descale the water tank
described in the section "Descaling mode".
NOTE
► You can store the sieve holder
holders
SEMM 1470 A1
, the sieve holder
:
back down again.
are also suitable for cleaning in the dishwasher.
in the appliance without the espresso sieve
with water (approx. 200 ml).
and rinses out the pipes. As soon as the water stops coming out of
, the cleaning process is complete.
next to the water tank.
after every drink prepa-
and the espresso outlet
from the sieve holder
and the sieve holder
and wait until all control
. The water comes out of the espresso
and the pipes, proceed as
and the espresso sieves
upwards
.
.
in warm water
.
.
in the
GB │ IE │ 59 ■