Drawing Hot Water; Cleaning And Care; Cleaning The Milk Frother - Silvercrest SEM 1100 D3 Bedienungsanleitung

Drawing hot water

You can also use the milk frother 0 to draw hot water; for example, to dilute
a coffee (café americano) or prepare tea .
1) Switch the appliance on using the On/Off switch 1 . The red operating
lamp z lights up . The "Espresso" control lamp t flashes white . Make sure
that the steam control 7 is turned in the direction of the " " as far as the
stop .
Wait until the pointer of the temperature indicator 2 is approximately half
way between 80°C and "
continuously .
2) Hold a heat-resistant container under the milk frother 0 .
3) Turn the steam control 7 at least half way towards " " .
4) Press the "Steam" button
milk frother 0 .
5) Press the "Steam" button
6) Close the steam control 7 (turn it as far as it will go in the direction " ") .

Cleaning and care

WARNING! RISK OF INJURY!
► Always remove the plug from the mains power socket before you clean the
appliance . Risk of electric shock!
► Always allow the appliance to cool down before cleaning it . Risk of burns!
Never immerse the appliance in water or other liquids! Risk of electric
shock!
CAUTION! PROPERTY DAMAGE!
► To avoid damage, never use abrasive, aggressive or chemical cleaning
agents to clean the surfaces of the appliance .

Cleaning the milk frother

1) Place an empty container under the milk frother 0 .
2) Immediately after use, turn the steam control 7 to the " " position and
allow the steam to escape for a few seconds .
3) Turn the steam control 7 off (as far as it will go in the direction " "), switch
the appliance off and remove the plug from the mains power socket .
4) Allow the nozzle to cool down .
5) Pull the casing of the milk frother 0 off (Figure 3) and clean it thoroughly in
warm water .
■ 16 │ GB │ IE │ NI │ CY
" and the "Espresso" control lamp t lights up
4 two times . Hot water will come out of the
4 again to stop the flow of hot water .
SEM 1100 D3