Confirmation Of Cip Testing; Health And Safety Of The Operator; Noise Information - Hilti DX 860-ENP Bedienungsanleitung

13. Confirmation of CIP testing

The Hilti DX 860-ENP has been system and type tested.
As a result, the tool bears the rectangular PTB approval
mark showing approval number S 814. Hilti thus guar-
antees compliance with the approved type.

14. Health and safety of the operator

14.1 Noise information

Powder-actuated fastening tool
Type
Model
Caliber
Power regulation
Application
Declared measured values of noise characteristics according to 2006/42/EC Machinery Directive in
conjunction with E DIN EN 15895
Noise (power) level:
Emission noise-pressure level in the work station:
Peak sound pressure emission level:
Operation and set-up conditions:
Set-up and operation of the pin driver in accordance with E DIN EN 15895-1 in the semi-anechoic test room of
Mü l ler-BBM GmbH. The ambient conditions in the test room conform to DIN EN ISO 3745.
Testing procedure:
Enveloping surface method in anechoic room on reflective surface area in accordance with E DIN EN 15895, DIN
EN ISO 3745 and DIN EN ISO 11201.
NOTE: The noise emissions measured and the associated measurement uncertainty represent the upper limit for
the noise values to be expected during the measurements.
Variations in operating conditions may cause deviations from these emission values.
1 ± 2 dB (A)
2 ± 2 dB (A)
3 ± 2 dB (C)
14.2 Vibration
Total vibration in accordance with 2006/42/EC does not
exceed 2.5 m/s².
Printed: 08.07.2013 | Doc-Nr: PUB / 5069855 / 000 / 01
Unacceptable defects or deficiencies, etc. determined
during use of the tool must be reported to the person
responsible at the approval authority (PTB) and to the
Office of the Permanent International Commission
(C.I.P.).
DX 860-ENP
Series
6.8/18 red
2
Fastening to 8 mm steel (390 MPa)
with X-ENP 19L15MX R
L 1 115 dB(A)
WA, 1s
L 2 104 dB(A)
pA, 1s
L 3 137 dB(C)
pC, peak
Further information about user health and safety can be
found at www.hilti.com/hse.
en
27