Confirmation Of Cip Testing; Cip Approval Mark; Health And Safety Of The User; Noise Information - Hilti DX351BT Bedienungsanleitung

13. Confirmation of CIP testing

The Hilti DX 351 BT and DX 351 BTG have been system
and type tested. As a result, the tools bear the square-
shaped PTB approval mark showing approval number
S 807. In this way, Hilti guarantees compliance with the
approved type.
en

14. Health and safety of the user

Noise information

The following table provides noise measurement information:
Powder-actuated tool
Type:
Model:
Caliber:
Power setting:
Application:
Declared measured values of noise characteristics according to 2006/42/EC Machinery Directive in
conjunction with E DIN EN 15895
Noise (power) level:
Emission noise-pressure level in the work station:
Peak sound pressure emission level:
Operation and set-up conditions:
Set-up and operation of the pin driver in accordance with E DIN EN 15895-1 in the semi-anechoic test room of
Mü l ler-BBM GmbH. The ambient conditions in the test room conform to DIN EN ISO 3745.
Testing procedure:
Enveloping surface method in anechoic room on reflective surface area in accordance with E DIN EN 15895, DIN
EN ISO 3745 and DIN EN ISO 11201.
NOTE: The noise emissions measured and the associated measurement uncertainty represent the upper limit for
the noise values to be expected during the measurements.
Variations in operating conditions may cause deviations from these emission values.
1 ± 2 dB (A)
2 ± 2 dB (A)
3 ± 2 dB (C)
Vibration
The declared total vibration value according to 2006/42/EC does not exceed 2.5 m/s
Further information regarding the health and safety of the user can be found at the Hilti web site: www.hilti.com/hse
28
Printed: 20.08.2013 | Doc-Nr: PUB / 5069824 / 000 / 02
All manuals and user guides at all-guides.com
Unacceptable/inadmissible defects, deficiencies, etc.
that are determined during use of the tool must be report-
ed to the manager responsible at the approval authori-
ty (PTB) and to the Office of the Permanent International
Commission (C.I.P.).
DX 351-BT / DX 351 BTG
Serial production
6.8/11 brown
3
Fastening of X-BT M10-24-6 onto pre-drilled steel
platting 8 mm thick
L
WA, 1s
L
pA, 1s
L
pC, peak
1 109 dB(A)
2 105 dB(A)
3 136 dB(C)
2 .