Declaration Of Conformity; Product Information; Safety Instructions - Hilti DX 6 Serie Original Bedienungsanleitung

1.3.3 Information shown on the display
The following information may be shown on the display:
This symbol indicates the battery's state of charge. When the battery is empty, the maintenance
symbol appears.
The "maintenance" symbol indicates that maintenance is due. It appears after 5 years, when
30,000 fasteners have been driven, or when the battery is empty. Our recommendation: Consult
Hilti Service.
The "fasteners driven" counter indicates when the next service is due. One segment stands for
500 fasteners driven. There are 5 segments in total, representing 2,500 fasteners driven.
This symbol indicates whether Bluetooth is switched on. If the symbol is not shown on the display
then Bluetooth is switched off.
1.4

Declaration of conformity

We declare, on our sole responsibility, that the product described here complies with the applicable directives
and standards. A copy of the declaration of conformity can be found at the end of this documentation.
The technical documentation is filed here:
Hilti Entwicklungsgesellschaft mbH | Tool Certification | Hiltistrasse 6 | D-86916 Kaufering, Germany
1.5

Product information

products are designed for professional users and only trained, authorized personnel are
permitted to operate, service and maintain the products. This personnel must be specifically informed about
the possible hazards. The product and its ancillary equipment can present hazards if used incorrectly by
untrained personnel or if used not in accordance with the intended use.
The type designation and serial number are printed on the rating plate.
▶ Write down the serial number in the table below. You will be required to state the product details when
contacting Hilti Service or your local Hilti organization to inquire about the product.
Product information
Fastening tool
Generation
Serial no.
2 Safety
2.1

Safety instructions

Basic safety precautions
WARNING! Read all safety instructions and other instructions. Failure to comply with the safety
instructions and instructions can cause serious injuries.
Keep all safety instructions and instructions for future reference.
▶ Do not tamper with or modify the fastening tool in any way.
▶ Use only items of equipment that are compatible with each other (fastener guide or magazine, piston and
fasteners).
▶ Check the fastening tool and accessories for damage.
▶ Moving parts must be in full working order; make sure that they cannot jam. Keep moving parts oiled.
▶ All parts must be correctly installed to ensure faultless operation of the fastening tool. Damaged
parts must be properly repaired or replaced by Hilti Service unless otherwise stated in the operating
instructions.
▶ Use only Hilti DX- cartridges, or other suitable cartridges that meet the minimum safety requirements.
→ page 24
▶ Do not attempt to drive fasteners into unsuitable base materials, for example material that is too thin, too
hard, or too brittle. Driving a fastener into these materials can cause the fastener to break, splinter the
material or be driven right through. Examples of unsuitable materials are:
▶ Weld seams in steel, cast iron, glass, marble, plastic, bronze, brass, copper, insulating material,
hollow brick, ceramic brick, thin sheet metal (< 4 mm) and cellular concrete.
▶ Comply with the 'Direct Fastening Technology Manual', the 'Technical Guide' and the operating
instructions of the fastener to be driven.
20 English
DX 6
01
2232121
*2232121*