Care And Maintenance - Hilti DX 860-ENP Bedienungsanleitung

Do not attempt to forcibly remove cartridges from the
cartridge strip or from the tool.
1. Push the cartridge strip into the tool at the cartridge
loading channel, in the direction of cartridge trans-
port, as far as it will go.
2. Pull the cartridge strip out of the tool at the cartridge
strip exit area.
7.3.2 Removing fastener strips from the tool
-NOTE-
It is not absolutely essential to remove fastener strips
from the tool.
-WARNING-
Check that the cartridge strip has been removed from
the tool. If a cartridge strip is present in the tool, remove
it by pulling it out of the tool by hand at the cartridge
strip exit area.
1. Stand the tool upright on the grip (upside down).
2. Press the release button (red button) above the fas-
tener magazine and allow the fastener strips to slide
out of the magazine.
3. Press the stop piece and cycle the tool until the fas-
tener strip projects from the tool.
4. While pressing the stop piece, pull the fastener strip
from the tool.
7.4 Remedying malfunctions
7.4.1 If the tool misfires or a cartridge fails to fire,
proceed as follows:
1. Press the tool fully against the work surface and pull
the trigger.
2. If the cartridge still fails to fire, lift the tool away from
the work surface. Do not point the tool toward your-
self or other persons.

8. Care and maintenance

-CAUTION-
When this type of tool is used under normal operating
conditions, dirt and residues build up inside it and func-
tionally relevant parts are subject to wear. Regular inspec-
tions and maintenance are thus essential in order to
ensure reliable operation.
Recommended interval for cleaning the tool and check-
ing the condition of the piston and piston stopper:
At least daily when the tool is subjected to inten-
●
sive use.
After driving 5,000 fasteners, at the latest.
●
-WARNING-
The tool must be unloaded before carrying out care and
maintenance.
Printed: 08.07.2013 | Doc-Nr: PUB / 5069855 / 000 / 01
3. At the cartridge loading side, advance the cartridge
strip by one cartridge by pushing the strip further into
the tool or, alternatively, by pulling the strip through
the tool by hand (by one cartridge) at the cartridge
strip exit area.
4. Use up the remaining cartridges on the strip. Remove
the used cartridge strip and dispose of it correctly to
prevent possible misuse.
7.4.2 If the tool jams, proceed as follows
-WARNING-
All cartridges must be removed from the tool.
-WARNING-
Do not attempt to forcibly remove cartridges from the
cartridge strip or from the tool.
1. Pull the cartridge strip out of the tool at the cartridge
strip exit area.
-NOTE-
Turning the rotating sleeve releases the catch. It jumps
open automatically and allows the tool to be opened.
2. Press the nosepiece of the tool in slightly and turn the
rotating sleeve through 90° (use the accessory scraper
as an aid if necessary).
3. Carry out the steps described at 8.2.1 or 8.2.2.
4. Turn the rotating sleeve subsequently back through
90° to its original position.
The tool may become hot during
●
operation.
You could burn your hands.
●
Wear protective gloves before
●
carrying out care and maintenance.
8.1 Care of the tool
Clean the casing of the tool at regular intervals with a
damp cloth.
-NOTE-
Do not use a spray or steam-cleaning system for clean-
ing. Never operate the tool when the ventilation slots are
-CAUTION-
21
en