Charging The Business Handset - Funkwerk FC3 Kurzanleitung

FC3‚ FC3 L
ATTENTION
The Desktop Charger DC4 Standard and the Desktop Charger
DC4 Plus are using different plug-in power supply units as far as
the pin assignment of the low voltage plug and the provided out-
put power are concerned.
Thus, the Desktop Charger DC4 Standard may only be operated using
the standard plug-in power supply unit, whereas the Desktop Charger
DC4 Plus may only be operated using the „Plus" plug-in power sup-
ply unit, order number 59 0060 2814.
Plug the small connector of the connecting cord into the charger at the rear.
Connect the plug-in power supply unit with a socket outlet.
The charger is now ready for operation.

Charging the business handset

Place the handset into the charger. You hear a confirmation tone provided this
feature has been activated in the "Phone settings > Audio settings >Tones > In
charger". The keyboard illumination lights up for a short time provided this fea-
ture has been activated in the "Phone settings > Displaysettings > Illumination
> Keyboard".
The handset switches itself on when it has been switched off before being
placed in the charger.
The battery symbol in the symbol line will be moving until the battery is fully
charged. The batteries heat up slightly during the charging process. This is
quite normal.
As soon as the battery is fully charged, charge retention starts. A fully charged
battery is indicated by a green "Battery charged" symbol with a flashing frame.
Putting into operation
93