Handling Of Chargers; End User Information On The Environmentally Friendly Disposal Of Old Units And Empty Batteries - Funkwerk FC3 Kurzanleitung

FC3‚ FC3 L
ration. For this reason – whenever possible – do not leave the handset or
the batteries in the blazing sun or near heat sources for an extended pe-
riod.

Handling of chargers

All socket-outlets supplying the plug-in power supply units of chargers must
be located near the chargers and be accessible at any time. The socket-
outlets must have been properly installed by qualified personnel.
Before connecting the plug-in power supply unit with the socket-outlet:
Ensure that the available mains voltage is the same as specified on the po-
wer supply unit (e.g.230 V, 50 Hz).
Chargers and their plug-in power supply units do not contain any service-
able parts.
Repairs must be made properly by trained personnel. Have defective or da-
maged chargers and power supply units replaced by original parts only,
even if only the cord is damaged.
CAUTION
Be careful when handling damaged plug-in power supply units!
Touching live parts is life-threatening!
Disconnect the socket-outlet from the supply (remove or switch off fuse of
respective circuit) before pulling a mechanically damaged plug-in power
supply unit out of the socket-outlet!
The chargers and plug-in power supply units are designed for use in an of-
fice-type environment. Protect them against heavy dirt, dust, moisture and
wetness as well as direct heat radiation. See page 125.
End user information on the environmentally friendly disposal of
old units and empty batteries
The returning and the environmentally friendly disposal of worn out electric
and electronic units is governed by the Law on electric and electronic devices,
observe the regulations of your local authorities, please:
Safety Information
83