Description Of Function Of Position Alarm Sequence - Funkwerk FC3 Kurzanleitung

The telephone features
NOTE
The 'Position alarm' is available only if one emergency number each
for this specific position alarm is configured for all private telecommu-
nications switching systems in which the handset is logged in, if no call
is in progress (configurable) and if the handset is within reach of the
GAP telecommunication system.

Description of function of position alarm sequence

Pre-alarm signalling of position alarm
When the 'Position alarm' is activated and configured, the handset identifies
an inclination of more than 55 ° from the vertical p osition and signals this
condition by
a pre-alarm signalling according to configuration „Position alarm > Pre-
alarm signalling" on page 135 and
«Pre-alarm» appearing in the status line and
«Position alarm» and «Emergency no.» in the text area of the display.
This is to announce the upcoming release of the emergency call by the posi-
tion alarm.
Avoiding the position alarm during pre-alarm signalling
During the parameterisable pre-alarm signalling, the handset user can avoid
the release of the emergency call (personal alarm) by moving the handset
back to a vertical position. This avoids the release of an emergency call follo-
wing a position alarm triggered by mistake.
If the user does not move the handset back to a vertical position during the pa-
rameterisable pre-alarm signalling, the handset will dial the parameterised
emergency number of the emergency call receiver (emergency call triggering,
personal alarm).
As soon as the emergency call receiver accepts this call (i.e. hooks off his tele-
phone set or handset), a voice connection between the „Handset in position
118
FC3‚ FC3 L