Storch Airless EasySpray ES 300 Betriebsanleitung Seite 56

Fault Cause
Spray gun stop- Spray tip is clogged.
ped spraying
Sprayer lost prime.
while trigger is
pulled.
Paint runs down Material is going on too thick.
the wall or sags
during spraying.
Insufficient Material applied too thinly.
coverage
Fan pattern vari- Pressure control switch is worn and
es dramatically causing excessive pressure variation.
while spraying.
Cannot trigger Trigger lock engaged.
spray gun.
Paint is coming Pressure control is worn.
out of pressure
control.
Paint is leaking Sprayer is over pressurizing.
through drain
tube.
Paint leaks down Pump packings are worn.
outside of pump.
Motor is hot and Vent holes in enclosure are plugged
runs intermit- or sprayer is covered.
tently. Motor
Extension cord is too long or not a
automatically
heavy enough gauge.
shuts off due to
Unregulated electrical generator
excessive heat.
being used has excessive voltage.
Damage can
occur if cause is
Motor needs to be replaced.
not corrected.
Remedy
Clear spray tip clog.
See troubleshooting section "Sprayer runs, but pump does
not prime or looses prime while in use."
Move gun faster.
Use a tip with a smaller tip hole.
Choose spray tip with wider fan.
Make sure the spray gun is approximately 25 - 30 cm
from the surface.
Move gun slower.
Select a tip with a large tip hole.
Choose spray tip with narrower fan.
Make sure the spray gun is approximately 25 - 30 cm
from the surface.
Contact the STORCH Service Hotline
Turn the trigger safety lock to disengage it.
Contact the STORCH Service Hotline
Contact the STORCH Service Hotline
Apply a new sealing kit to the pump seals.
Keep vent holes clear of obstructions and overspray and
keep sprayer open to air.
Replace the extension lead.
Use electrical generator with a proper voltage regulator.
Contact the STORCH Service Hotline
56