Storch Airless EasySpray ES 300 Betriebsanleitung Seite 45

stroke, overlapping each stroke by half.
Spray Pattern Quality
A good spray pattern is evenly distributed as it hits the
surface.
The spray pattern must be atomized (evenly distributed,
no gaps).
Tails, gaps at the edges, insufficient pressure
If tails persist when spraying at the highest spray pres-
sure:
• Spray tip may be worn. See spray tip selection.
• A smaller spray tip may be needed.
• Material may need to be thinned. If material needs to
be thinned follow manufacturer's recommendations.
Clear Tip Clog
In the event that particles or debris clog the spray tip, this
sprayer is designed with a reversible spray tip that quickly
and easily clears the particles without disassembling the
sprayer.
See the section on straining the paint for additional infor-
mation.
1. Release the trigger. Engage trigger lock. Turn the tip
to cleaning position (arrow of the tip pointing towards the
rear).
2. Disengage the trigger lock. Point the spray gun at the
waste pail and briefly pull the trigger to unclog it.
Unclog
3. Engage the trigger safety lock. Turn the tip back to the
spray position (arrow once again points towards the front).
4. Disengage the trigger safety lock and continue
spraying.
Spray
Good spray pattern
45