Using Sensorcontrol Plus - Bosch OptiMUM MUM9 Serie Gebrauchsanleitung

Using the timer without processing food:
■ Press button A. „05:00" appears on the
display.
■ Set the required processing duration
using button + or -.
■ Press button A briefly twice to start the
timer.
■ The remaining duration will be shown
on the display and the countdown will
continue.
■ Once the duration has elapsed, an
acoustic signal sounds. "FINISH TIMER"
appears on the display.
Notes:
– Press button A briefly twice to stop the
timer or to start it again.
– If food starts to be processed while
using the timer, the appliance will
continue to run until the remaining
duration has elapsed and then stop
processing automatically.

Using SensorControl Plus

Depending on the model, the appliance
may be equipped with SensorControl Plus
automatic programmes. Sensors monitor
the processing of the ingredients and switch
the appliance off once the pre-programmed
consistency has been reached.
The following automatic programmes are
available with SensorControl Plus:
– CREAM
Automatic preparation of whipped cream
– EGG WHITE
Automatic preparation of (beaten) egg
white
– YEAST DOUGH
Automatic preparation of yeast dough.
Using SensorControl Plus
Selecting programme
■ Press button D. "CREAM" appears on
the display.
■ Press button + or -. The following
programmes appear in sequence:
Programme Tool/Ingredients
Professional stirring whisk
CREAM
>300 ml * 300-700 ml cream
Professional stirring whisk
CREAM
>700 ml * 700-1500 ml cream
EGG WHITE Professional stirring whisk
White of 2-12 eggs
Kneading hook
YEAST
Ingredients and quantities
DOUGH
according to the recipe
X "Recipes" see page 34
* For appliances with integrated scales,
the options ">300 ml" and ">700 ml" are
not displayed for "CREAM". "0g" flashes on
the display. If a quantity of cream between
300 ml and 1500 ml has been added,
the display shows the quantity and the
appliance automatically uses the correct
settings. If less or more cream is added, the
displayed weight will flash.
Notes:
– Before using the automatic
SensorControl Plus for the first time, the
food processor must have been running
for at least two minutes to ensure that
the sensors function correctly.
– Press button A to abort the programme
selection. „OptiMUM" appears on the
display.
– The function buttons are locked when
SensorControl Plus is in use.
– Do not fill any additional ingredients after
SensorControl Plus has been started.
– SensorControl Plus is only programmed
for the described tools and food
(in the specified quantities). Other
combinations are not possible.
– The age, the temperature and the
contents of the ingredients affect the
time required and the result.
en
31