Herunterladen Inhalt Inhalt Diese Seite drucken

Re-Adjustment Of Tools; Safety Systems; Overload Protection; Disposal - Bosch OptiMUM MUM9 Serie Gebrauchsanleitung

Vorschau ausblenden Andere Handbücher für OptiMUM MUM9 Serie:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
en

Re-adjustment of tools

Re-adjustment of tools
W Risk of injury!
Pull out the mains plug before re-adjusting.
Caution!
Only re-adjust tools in small steps. It must
be possible to completely lower the swivel
arm, and when doing so, the tools should
not catch on the bottom or on the edge of
the bowl. The optimum distance between
the tools and the bowl is 3 mm.
X Image sequence O
■ Insert the professional stirring whisk and
check the current setting.
■ Press the release button and raise
the swivel arm to the stop.
■ Hold the tool with one hand. Release
the lock nut in a clockwise direction
using a spanner wrench (10 mm).
■ Adjust the distance to the bowl by
turning the tool (1 whole turn corre-
sponds to a height adjustment of 1 mm).
Turn anticlockwise:
Distance to bowl is reduced.
Turn clockwise:
Distance to bowl is increased.
■ Press the release button and push the
swivel arm down until it locks into place.
■ Check the tool distance. The optimum
distance between the tools and the bowl
is 3 mm. Adjust if necessary.
■ Once the distance is perfectly adjusted,
press the release button and move the
swivel arm back.
■ Hold the tool with one hand. Turn the
lock nut in an anticlockwise direction
using a spanner wrench (10 mm).

Safety systems

Start lock-out
The appliance can only be switched on if
the bowl has been inserted and turned until
it locked into place, or if an accessory has
been secured to the main drive with the
bevel gear, and if the swivel arm is locked
into the lower position.
36
Automatic power-on safety lock
If the power is interrupted, the appliance
remains switched on, but the motor does
not start again when power is restored.
To switch back on, first turn the rotary
switch to y, and then switch on again.

Overload protection

The overload protection will switch the
motor off automatically during operation.
One possible cause may be processing
too much food at once.
Swivel arm protection device
The swivel arm will not unlock and move
if an accessory is fitted to the rear drive.

Disposal

J
Dispose of packaging in an environ-
mentally-friendly manner. This
appliance is labelled in accordance
with European Directive 2012/19/EU
concerning used electrical and
electronic appliances (waste electrical
and electronic equipment – WEEE).
The guideline determines the frame-
work for the return and recycling
of used appliances as applicable
throughout the EU. Please ask your
specialist retailer about current
disposal facilities.

Guarantee

The guarantee conditions for this appliance
are as defi ned by our representative in the
country in which it is sold. Details regarding
these conditions can be obtained from
the dealer from whom the appliance was
purchased. The bill of sale or receipt must
be produced when making any claim under
the terms of this guarantee.
Changes reserved.

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis