Using The Time And Timer Function - Bosch OptiMUM MUM9 Serie Gebrauchsanleitung

en

Using the time and timer function

X Image sequence H
1. To add larger quantities or ingredients,
turn the rotary switch to y. Wait until
the drive comes to a standstill.
2. Press the release button and raise
the swivel arm to the stop. „ARM OPEN"
appears on the display.
3. Add the ingredients directly to the bowl.
Press the release button and push the
swivel arm down until it locks into place.
"OptiMUM" appears on the display.
Continue processing your ingredients.
Note: By opening the arm, the elapsed
processing duration is reset to "00:00".
Using the time and timer
function
The appliance features a time and timer
function. The following functions are
available:
"TIME" function
Display of the elapsed processing duration
(standard setting). The "TIME" function
starts automatically once the processing of
food has been started.
Notes:
– Hold button A down while processing to
reset the duration to "00:00".
– After processing or when it is
interrupted, hold button A down to
display the start screen. "OptiMUM"
appears on the display.
"TIMER" function
Setting of a required duration. Once the
duration has elapsed, an acoustic signal
will sound and processing will stop.
The function may also be used without
processing food (e.g. for boiling or resting
times of food).
X Image sequence I
1. Prepare the appliance. Add ingredients.
2. Plug in the appliance. "OptiMUM"
appears on the display.
3. Press button A. "05:00" appears on the
display.
30
4. Set the required processing duration
using button + or -. The values will
change faster if the respective button
is pressed and held down. The set
processing duration will remain saved
for approx. 5 minutes.
5. Set the rotary switch to the required
setting.
6. The remaining duration will be shown
on the display and the countdown will
continue.
7. Once the remaining duration has
elapsed, an acoustic signal will sound
and the appliance will stop processing
automatically. "FINISH TIMER" appears
on the display.
8. „TURN SWITCH TO 0" appears on the
display.
9. Turn the rotary switch to y. "OptiMUM"
appears on the display.
10. Disconnect the mains plug.
11. Processing with the "TIMER" function is
ended.
Clean all parts immediately after use.
X "Cleaning and maintenance" see
page 34
Notes:
– If a duration of more than 60 minutes
is set, hours will also be displayed:
"1:01:30".
– Press button + or - at any time to
adjust the displayed remaining duration.
– Press button A briefly twice to stop the
timer (the appliance will continue to run)
or to start it again.
– Turn the rotary switch to E to interrupt
processing. The remaining duration
remains saved and the countdown will
continue after the appliance is switched
on again.
– Hold down button A to switch the timer
off. "OptiMUM" appears on the display.
"TIME" then appears and the elapsed
processing duration is displayed.